my latest project

After selling my campaign project i instantly regretted it and needed another tintop project . ( as my campaign project is no more decided i would over write my new project on the old campaign project pages) So i bought another mk1 as it was only 30 miles from me. Arrived with many parts missing,  more than i actually realised, for instance no accelerator pedal. I found one on ebay and here it is brought back to shiny metal awaiting its repaint..

 

Last edit: 19 May 2020, 10:15 AM by abfmk1

PAINTED

Last edit: 19 May 2020, 11:14 AM by abfmk1

Last edit: 03 November 2019, 9:14 AM by abfmk1

Last edit: 03 November 2019, 9:16 AM by abfmk1

Last edit: 03 November 2019, 9:18 AM by abfmk1

Last edit: 03 November 2019, 9:19 AM by abfmk1

 Nice painted wishbones, with new ball joints and rubbers, and a nice rust free pair of rear w/bone mounts with new clamps ,  and new stainless wishbone/ antiroll bar mounts

Last edit: 03 November 2019, 2:09 PM by abfmk1

Painted up original strut housings, new/unused febi top mounts and new/unused bilstien b4 inserts.

Last edit: 03 November 2019, 3:29 PM by abfmk1

 The unused so far,  1.8t engine and 02j gearbox conversion mounts.

Last edit: 06 November 2019, 4:41 AM by abfmk1

Cabriolet 100 mm hub assemblies, derusted, painted and new wheel bearings inserted

Last edit: 07 November 2019, 11:48 AM by abfmk1

New rear B4 bilsteins with new bump stops and used springs..

Last edit: 19 November 2019, 10:19 AM by abfmk1

Used ABF flywheel with new bolts and new vr6 clutch assy to replace standard 1.8t flywheel assy. Usual recomended conversion.

Last edit: 19 November 2019, 10:35 AM by abfmk1

Used pair of 100mm driveshafts

Last edit: 19 November 2019, 10:45 AM by abfmk1

New unused steering rack with new unused steering arms ( i planned to put an adjustable arm on both sides ) and new unused rubber gaiters.

Last edit: 19 November 2019, 11:26 AM by abfmk1

Modified brake cross over linkage to allow fitting of clutch master cylinder..

Last edit: 20 November 2019, 1:26 PM by abfmk1

New/unused 16v type cambelt tensioner and new/unused epytec spacer. These are needed as original 1.8t tensioner fouls on the modified mk1 golf conversion mount, and needs removing.

.

Last edit: 20 November 2019, 1:31 PM by abfmk1

Engine / gearbox in



 

Last edit: 26 November 2019, 2:41 PM by abfmk1

New unused intercooler,  which i will not fit at the moment.

Last edit: 26 November 2019, 2:44 PM by abfmk1