Diverter Valve small hose outlet

Hi,

I am installing a forge 007 diverter valve onto my 20vt conversion. Am I right in thinking that the small hose outlet on the top of the valve is for a vacuum?

If so do I connect a pipe from there to the pipe on the right of the intake manifold for the vacuum, along with my servo pipe being connected to the intake manifold?

Cheers

you should have some vacuum takeoff points on the underneath of the inlet manifold

leave the brake servo vacum on the right hand side of inlet manifold alone . like jonp said  there is 3  takeoff on the bottom of the  inlet manifold 1 big 2 small.  use 1 of the small nipple . if they both are  being used  use a small t piece and use that as source.

Cheers, and then its just a straight pipe from the inlet vacuum to the diverter?

thickfreakness said

Cheers, and then its just a straight pipe from the inlet vacuum to the diverter?

thickfreakness said

Cheers, and then its just a straight pipe from the inlet vacuum to the diverter?

ontop of valve yes. just get some silicon piping 2 quid on ebay 6-8 mm