My Cabby project

Been some time since I put any pictures up of my cabby





Powered by a 1.8T




Corrado interior, including dash, center consel, front recaros and back seat.

hi, nice insall! the rear bench do you have to cut in half to get it to fit write? if so how much did you shorten it by? how hard was fitin' corrado dash? anyway lookin' good!

I like it alot!
What wheels are those? They look like smaller versions of a wheel that you can get on the range rover sport.
Like the smooth bay.
Like the interiour.
Like the engine.
Good job.

Thanks for your comments

jon130y, I took 30mm of the height of the rear seats to clear the roof as it goes up and down.

The Corrado dash wasn't to bad to fit but I am also using a complete Corrado loom which I cut about so's to keep the fuse box in the same place.

The wheels are 16's from a Rover 25 which is why they look similar to the range rover.