I manufacture p-slot centre caps!

Hi all,

I have been messing around with my 3D printer and have managed to knock up a 3D printed centre cap for Pirelli's. 



I'm looking to manufacture them on request, sell them and improve them as time goes on.

I am going to look for a claw on the back that Is compatible with the p slot rims.

I am also going to try and mess around with getting the Pirelli embossed on the top. 

If not I am going to use stickers from crazyquiffs and lacquer to seal it.

Let me know if there's any interest!! And I can let you know of cost etc

Cheers,
Alex

I don't have P-slots but gold star for what you have achieved so far.

Thankyou!! Will keep the post updated as I progress with orders etc already got a few in the works, only posted this morning!!!

Early-1800 said

I don't have P-slots but gold star for what you have achieved so far.

Thankyou!! Will keep the post updated as I progress with orders etc already got a few in the works, only posted this morning!!!

how are you going to stick them in? ive a set of fiat ? covers that have a standard  56mm? centre cap glued in the centre.

Kenneth Cartwright said

how are you going to stick them in? ive a set of fiat ? covers that have a standard  56mm? centre cap glued in the centre.

I've designed them to have a recess in them to accommodate for a standard cap off the internet. When I used the 56mm one it seemed a bit tight so I've ordered the next one down to see how it fits

Good stuff Alex,your bound to find a market though you need to get them to fix on and come off properly.
I would have loved a set but I sold the wheels years ago for next to nothing! as i did not realise what they wereMarcus.