Mk2 16v Brake Servo

Hi,

I've recently fitted a Mk2 16v Brake Servo to my Mk1 Golf G60. To help uprated the brakes!!

Underneath the master cylinder is a small block which a brake pipe runs from the master cylinder into this block, then another brake pipe comes from the otherside of the block and runs down to the back brakes. On this block at the bottom there is two spade connectors.

Do these connectors need connecting to the wiring loom??

Thanks

is this not the switch for the brake lights.

Could be the sensor for the low brake pads  :dontknow:
but then i thought that was just a small single wire..

it is the switch for the brake lights!!!!!