Rear Panel removal

Cant for the life of me fine a thread with the Rear panerl (Full) removal guide on it.

Im sure k33ts had a good one,

can anyone give me a link?

Scott

if the boot floor is ok, drill out the spot welds holding it to the rear panel, then just follow the sides down with the grinder dont go too close, so you have metal to weld the new1 to.
use the new panel to see what bit of the old panel you can remove, take your time make sure both sides are mint then start welding her up. when its off have a good look and check there is no more rust lurking ready to start eating your new piece.
nice and slow, it what i did any way, workd for me!!
cheers