dodgy window!

Hi all!
Right, this is my problem, for some reason unknown to me, my drivers door window is getting stuck behind the seal as I do the window up. It seems to fall back behind the rubber about 3 inches down, then as you wind it up it gets stuck….and the only way i can wind it up fully is push the top of the glass out as I wind, or open the door and do it up (neither a good idea while moving!) checked the insdie of door, and all the track and fixings seem solid and fine. Anyone have a suggestion??

Is this on a cab or tin top?

Have you had the door card off to check the glass mount on the regulator?

sorry what a ****, its a cab, yeah I have had the door card and checked it all….. :dontknow:

It seems to me that the bottom of the glass is being pushed out causing top to bind with the rubber.  I suggest you strip out the whole lot and remove the glass and inspect all the guides etc for wear, cracks etc.

Mine used to do this too.

I wedged a little block of wood in the door to stop it tilting backwards as the window went all the way down.

Think I have a piece of old widow seal in there now so it looks like it is supposed to be there… rather than a manky bit of mouldy old pine!

yeah I tried wedging something in there before, guess I put it in wrong place, I'll take it all out and put it all back in again, and then try wedging it again if I cant sort it, thanks all.

there should b a buffer to guide the window up i had the same problem found the buffer in th ebottom of my door. theres a metal shelf it should stick to above the door lock