Tappit settings for 1.8 CARB engine???? URGENT PLEASE HELP??

mines a 1.8 carb, could you do me huge favour and look to see what the tippet settings and sequence for the 1.8 engine are???????

 would they be the same as the GTI? was the 1.8 carb engine only issued to the clipper?  

this would really help me out!!! thanks!!!!!!!!!

really appreciate your help!

please PM me with results!! getting my car serviced tomorrow and can hear tiny tapping noises

thanks again!!!!

1.8 in a Clipper is almost certainly going to be hydraulic self adjusting tappets.

Its not unusual for them to rattle a bit at startup but should quieten down after a min or two.

You could try some engine flush and a new filter and fresh oil to see if that works.

not sure if theyre hydraulic but ill try that! thanks very much!

http://www.clubgti.com…9&highlight=clean+tappets
I actually know really little about engines.
I just remember reading this a while back.

On my old Mk1 1.6 carb engine it was a solid lifter head. I dumped that in the bin, and stuffed a Mk2 GTi head on. Loads better.